|
|
|
|
|
|
|
|
|
|
|
LEFT HAND THREAD ADJUSTING SPINDLE FOR WEINIG P23E
|
FEED BEAM RAISE LOWER GEARBOX REBUILT AND READY TO INSTALL WITH NEW BRASS INSERT FITS MOST WEINIG AND SOME WADKIN MOULDERS
|
Gear box for feed rollers, Single right hand with shaft for table roller
|
|
|
|
|
|
|
|
|
|
|
|
|
Carden Drive Gear box for double feed rollers. Without shaft for bottom feed roller.
|
Profile Jointer for H23C Weinig. Reconditioned
I also have a new one available
|
Jointer blocks for Weinig H22B, H22A, U22A, This set includes both the front stroke and back stroke blocks, Rebuilt with new seals. Can sell separate please call 704-528-3513
|
|
|
|
|
|
|
|
|
|
|
|
|
We offer a large assortment of metric motors by manufacturers such as Siemens, Bauknecht, Brooks/Hansen, Weinig and others. We have motors with RPM from 510 to 3600 and available in several voltages.. We have a few brake motors available. Call for details. 704-528-3513 Prices vary depending on horsepower and status of brake versus non-brake motor. We also offer invertors to provide braking for your existing motors
|
ROTEX COUPLING WITH INSERT 28MM BORE X 90MM LENGTH
|
Side Pressure Unit for Weinig moulders
|
|
|
|
|
|
|
|
|
|
|
|
|
Single feed roller gear box with table roller flange mount
|
Straight Bottom Jointer for H22B, H22A, U22A Weinig. This unit comes complete with mount and stone holder. Reconditioned
|
Profile Jointer for H22B, H22A, U22A Weinig. This unit comes complete with mount and stone holder. Reconditioned Fits top spindle
|
|
|
|
|
|
|
|
|
|
|
|
|
Top chip breaker for Weinig H22B, H22A, U22A and several other machines. Rebuilt and ready to install.
|
Top gear box for radial adjustment, H23, U23. Adjustment of dovetail that houses the spindle. Note: The length of the shaft determines top or bottom.
|
Top spindle gearbox for Weinig H22B, H22A, U22A, H17B and other models. Part shown includes rubber boot (not shown) and is setup for use with a Siko counter. Siko counter available also. Other similar gearboxes available. 704-528-3513
|
|
|
|
|
|
|
|
|
|
|
|
|
Top spindle slide head for holding the complete spindle assembly. Fits Weinig H22B,H22A,U22A,H17B. Call for available. 704-528-3513.
|
Reconditioned universal assemblies, spline mount
|
Universal Assembly. Flanged on both ends with for bolt holes. 410mm length.
|
|
|
|
|
|
|
|
|
Weinig Universal Joint Shaft 270mm length Splined on both ends. Replacement for 00360711 and 00360730 Commonly used on many machines for feed wheels above wood.
CALL FOR AVAILABLITY OF USED ASSEMBLILES
|
|